20 (E)ENGLISHSetting the functions Setting the speed at which tomove to the position set by thepreset memoryThe speed at which to move to the position where theremote camera has been set to be in the preset memorywhen the preset operation is conducted can be set.From the [SETUP] menu, select [PRESET] and display[DIAG SPEED]. Then set the speed.The higher the setting, the faster the operating speed.1.DIAG SPEED ▼1 Setting the operations to beperformed when a presetoperation is executedThe operations which the remote camera is to performedwhen the preset operation is conducted can be set.From the [SETUP] menu, select [PRESET] and display[SCOPE]. Then set the operations to be performed.2.SCOPEMODE AThe operations that the camera performs when a presetoperation is executed differ depending on the modeselected.Mode Operations performedMODE A Pan, tilt, zoom, focus, iris, gain, white balanceMODE B Pan, tilt, zoom, focus, irisMODE C Pan, tilt, zoomThis function takes effect when the unit is connected tothe AW-HE50. It does not work with any other models.Note Returning the remote camerasto their home positionThe remote cameras connected can be returned to theirhome position.From the [SETUP] menu, select [PRESET] and display [HOMEPOSITION]. Then press the F2 dial.3.HOME POSITION▲SET Adjusting the panning, tilting,zooming and focusing speedThe speed is adjusted uniformly for the panning, tilting,zooming and focusing together.When the PTZ/FOCUS SPEED dial is turned clockwise,the speed is increased; conversely, when it is turnedcounterclockwise, it is reduced.PT ACTIVEAUTOIRISAUTOHILOWPTZ/FOCUS SPEED PAN/TILTFOCUS/PUSH OTAFZOOMWIDECAMERA STATUS / SELECTION1 2 3 4 5From the [SETUP] menu, select [OPERATE] and display[SPEED TARGET]. If P/T is selected, the speed adjustment isconfined to panning and tilting only.In this case, the zooming and focusing speed is fixed to thespeed which was set immediately before P/T was selected.