Panasonic Diga DMR-E95H Operating Instructions Manual

Also see for DMR-E95: Firmware instructions

Contents

8RQT7392Getting startedSTEP 1 Connection≥You need to subscribe to a cable TV service to enjoy viewing their programming.≥Consult your service provider regarding appropriate cable TV box.≥If you receive your programming solely from a satellite service, the program guide in this unit will not receive program listings orchannel information. Without this information, program-based recordings cannot be made. However, recordings can still be setmanually.A to Q are indexes for Spanish Quick Reference.§ For more information on connections (➡ page 7)∫ Should I use the AUDIO/VIDEO OUT terminal orthe RF OUT terminal?If your cable TV box has both AUDIO/VIDEO OUT terminals andRF OUT terminals, we recommend connecting the AUDIO/VIDEOOUT terminal with the unit’s IN3 (L3) terminal. Using thisconnection provides better picture quality.≥The S-VIDEO terminal achieves a more vivid picture than theVIDEO terminal.Place the IR Blaster in front of the signal sensor of the cable TVbox.Connecting a cable TV boxY PB P RR - AUDIO - L VIDEO S-VIDEOR - AUDIO - L VIDEO S-VIDEOOPTICALG-LINK (L1)(L3)COMPONENTVIDEO OUT(480P/480I) DIGITAL AUDIO OUT(PCM/BITSTREAM)IN1 IN3R - AUDIO - L VIDEO S-VIDEOR - AUDIO - L VIDEO S-VIDEOOUT1 OUT2 VHF/UHFRF INRF OUTVHF/UHFRF INVIDEO S-VIDEO RFR LAUDIOAUDIO INR L S VIDEO INVIDEO INOUT IND 75 ≠ coaxialcable§B This unitL From antenna orcable TV jackK Cable TV boxC Audio/video cableA TelevisionC Audio/video cable§I S-Video cableH Connect to either thisunit’s RF IN terminal orIN3 (L3) terminal.F Use IN3 (L3) [not IN1 (L1)].J Setting the IR Blaster➡ belowD 75 ≠ coaxial cableE IR BlasterInsert the IR Blaster jack intothe G-LINK terminal.The cable TV box iscontrolled by an IR signaltransmitted through the IRBlaster.When selecting channels onthis unit, the correspondingchannels on the cable TVbox also change accordingly.≥Only use the included IRBlaster.G Red White YellowG Red White YellowSetting the IR BlasterM Read the cable TV box operating instructions regardingpositioning of the signal sensor.N If necessary, use the double sided adhesive tape (included) tosecure the IR Blaster to a flat surface.Q If you peel off the adhesive tape, thesurface may become damaged.Once you have confirmed the cable TVbox is operating correctly, secure it byattaching the adhesive tape.O e.g. Television stand surfaceP Cable TV box