Panasonic Diga DMR-EZ48VEB Operating Instructions Manual

Contents

29RQT9126Notes Only one piece of DV equipment (e.g., digital video camcorder)can be connected to the unit via the DV input terminal. When timer recording starts while recording from an externaldevice, timer recording takes priority and recording from theexternal device stops. If the desired audio is not recorded, select the kind of audio for“Audio Mode for DV Input” in the Setup Menu (¼ 65). [RAM] Programmes are recorded as a single item; breaks in theimages create chapters and playlists are created automatically. If you use video camcorders from other manufacturers, these arenot guaranteed to work. Depending on the DV equipment, the images or audio may not beinput properly. The DV input on this unit is for use with DV equipment only.(It cannot be connected to a computer, etc.) It is not possible to operate the unit from the connected DVequipment. The DV equipment name may not be shown correctly. Date and time information is not recorded, even if displayed onthe camcorder. You cannot record and play at the same time.Connect the cable while both the unit and the externaldevice are turned off.Front of the unitS VIDEOIN 2 VIDEO /MONO AUDIO RL4-pin DV Cable[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]REC MODEto select the recordingmode (¼ 24).Turn on the DV equipment andpause play at the point you wantto start recording. DV Auto RecRec to DVD CancelDV unit is connected.Record from the DV unit?OK RETURNSELECT“DV Auto Rec”screen may appear. to select “Rec to DVD”, thenOK to select “Rec”, then OKRecording from a DV CamcorderTipsWhen recording finishesThe confi rmation screen appears.Press [OK] to fi nish DV camcorder recording.To stop recordingPress [ STOP].The confi rmation screen appears. Press [OK].If the DV camcorder recording function does not work properly,check the connections and DV equipment settings, and turn theunit off and back on. If that does not work, follow the instructions onpage 28Preparation: Turn on the unit. Insert a disc (¼ 73). [RAM] If the disc is protected, release protection(¼ 60). When the output signal from the external device isNTSC, change the “TV System” to “NTSC” in theSetup Menu (¼ 67).When recording bilingual programmes (¼ 65)When “DV Auto Rec” screen does not appearPerform steps – (¼ above).1. Press [DRIVE SELECT] to select the DVD drive.2. Press [FUNCTION MENU].3. Press [, ] to select “To Others”, then press [OK].4. Press [, ] to select “DV Auto Rec”, then press [OK].You can proceed to step  (¼ right).Advanced FeaturesAdvanced Features