9RQT9126 Before connection, turn off the mains for all connected equipment and read the appropriate operatinginstructions.Be sure to read the Caution for AC Mains Lead on page 3.Adding a Satellite Receiver: Connecting to a Television and a Satellite ReceiverConnections other than the 21-pin Scart cable 71 RF coaxial cable (supplied) from the aerial socket or aerial cable to the “RF IN” on the unit. RF coaxial cable (supplied, black) from the “RF OUT” on the unit to the “RF IN” on the TV. 21-pin Scart cable (not supplied) from the “AV1 (TV)” on the unit to the “AV” on the TV. 21-pin Scart cable (not supplied) from the “AV” on the satellite receiver to the “AV2 (EXT)” on theunit. AC mains lead (supplied) from the “AC IN~” on the unit, the TV and the satellite receiver to ahousehold mains socket.After completing the above connections, proceed to the TV Tuning (¼ 11).To view satellite programmesRefer to “Watching Satellite Programmes” (¼ 16)To record satellite programmesRefer to “Recording from a Satellite Receiver” (¼ 27)AC INRFINRFOUTOPTICALDIGITAL AUDIO OUT(PCM/BITSTREAM)COMPONENTVIDEO OUT OUTOUTVIDEOAUDIOLRPRPBYS VIDEOAV 2AA(EXT)TTAVAA 1V(TV)AC INRFRFININRFRFOUTOUTAV 1(TV)AV 2(EXT)Rear of this unitRear of TVRear of satellite receiverAV1Step4Step5StepRF INAV5Step5Step3Step2StepThe RF coaxial cablecannot be used for showingpictures from the unit. Theunit must be connectedusing another method, e.g.21-pin Scart cable to showpictures from the unit onthe television set.To the aerialTo householdmains socketTo householdmains socketTo householdmains socketsatellite antennaQuick Start Guide STEP 2Using a fully wired 21-pin Scart cable– You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (¼ 46).– You can enjoy high-quality viewing by connecting the unit to an RGB compatible television.“AV1 Output” in the Setup Menu is set to “RGB 1 (without component)” or “RGB 2 (without component)” (¼ 67)– “AV2 Input” settings in the Setup Menu (¼ 67)Use one of the RFcoaxial cable (black orgrey) to connect thisunit’s RF IN terminalto your aerial socket oraerial cable. (¼ 8)