84RQT9126PageGeneral Issues DVB-T (Continued)Unusual station sorting. The station sorting of this unit is pre-defined. Use profiles to sort thestations as you want them.62The digital channel informationdoes not appear. Select the length of time (3–10 sec.) in the “On-Screen Messages” in theSetup Menu.66 The digital channel information will not appear during playback orrecording. Perform “Auto-Setup Restart” in the Setup Menu.−63No Digital TEXT When subtitle is on or additional information in the digital channelinformaion is displayed, Digital Text does not work. Perform “Auto-Setup Restart” in the Setup Menu.−63After the Auto-setup, there aren’tany stations in the station listalthough found stations weredisplayed during Auto-setup. “Shipping Condition” was performed or the unit was in the delivery status.The auto setup was then started and interrupted.Do an auto setup again and let it continue right through to the end.The data is only saved after this has been completed.−The Signal Strength is over 100%(> 10) Reduce the signal amplification at your aerial. 63Poor picture in spite of good signalquality. Overmodulation makes the signal strength display go to red.Readjust the picture with your room aerial until the picture qualityimproves.−PageGeneral Issues VIERA LinkVIERA Link doesn’t work. Check the HDMI cable connection. Check that “HDMI” is displayed on thefront display when the power for the main unit is set to On. Make sure that “VIERA Link” is set to “On”. Check the “HDAVI Control” settings on the connected device. Some functions may not work depending on the version of “HDAVIControl” of the connected equipment. This unit supports “HDAVI Control 3”functions. If the connection for the equipment connected with an HDMI cable waschanged, or if there was a power failure or the plug was removed fromthe household mains socket, “HDAVI Control” may not work. In this case,perform the following operations.1. When the HDMI cable is connected to all equipment with the power on,turn the TV (VIERA) on again.2. Change the TV (VIERA) settings for the “HDAVI Control” function tooff, and then set to on again. (For more information, see the VIERAoperating instructions.)3. Switch the VIERA input to HDMI connection with this unit, and after thisunit’s screen is displayed, check that “HDAVI Control” is working.−67−−−The control panel does not appear. The control panel is only displayed when connected to a TV with “HDAVIControl 2” or “HDAVI Control 3” function.47Troubleshooting Guide