80RQT9126Use this function to synchronize the codes for theremote control and the main unit when there are otherPanasonic products close to your unit.With the unit stopped Press [FUNCTION MENU]. Press [, ] to select “To Others”, then press [OK]. Press [, ] to select “Setup”, then press [OK]. Press [, ] to select “Others”, then press []. Press [, ] to select “Remote Control”, then press[OK]. Press [, ] to select the code (“DVD 1”, “DVD 2”or “DVD 3”), then press [OK].Setup Remote ControlPress “” and “OK” togetherfor more than 5 seconds on the remotecontrol.DiscPictureSoundDisplayTuningConnectionVHSOthers OK RETURN While pressing and holding [OK],press and hold the numbered button [1], [2] or [3]corresponding to the code set in step for morethan 5 seconds to set. Press [OK] to complete.When the following indicator appears on the unit’s display– Change the code on the remote control to match the codedisplayed for the main unit (¼ step ).To Reset This UnitTo reset the unit’s settingsTo reset the ratings level settingsTo restore the unit if it freezesWith the unit stopped Press [ OPEN/CLOSE] to open the disc tray. Press [DRIVE SELECT] to select the DVD drive.On the main unit Press and hold [ REC] and [] for about 5seconds.When Other Panasonic ProductsRespond to this Remote ControlTipsTo return to the previous screenPress [RETURN].To exit the screenPress [EXIT].All the settings except for the ratings level, ratings password,Owner ID and Clock return to the factory preset. The timerrecording programmes are also cancelled.On the main unitPress and hold [ CH] and [CH ] for about 5seconds.– Refer to Tips of “Auto-Setup Restart” (¼ 63) for detailinformation.On the main unitPress and hold [/I] for more than 10 seconds.– The unit is turned off.Troubleshooting Guide
