78RQT9126On the Unit’s Display PageH , F(“ ” stands for a service number.) An error has occurred. The number following “H” or “F” depends on the statusof the unit. Check the items below and in the Troubleshooting Guide. If theservice number still does not disappear after the check, reset the unit (¼ 80,“To restore the unit if it freezes”).− If the service numbers fail to clear, note the service numbers and contact aqualified service person.−DVD(“ ” stands for a number.) The remote control and the main unit are using different codes. Change thecode on the remote control.80GUIDE TV Guide data is being downloaded. 68HARD ERR If there is no change after turning the unit on and off, consult the dealerwhere the unit was purchased.−NoCASSETTE You have not inserted a video cassette for the recording. 74NoERAS You cannot delete items on this disc.The disc may be damaged. Use a new disc.−NoREAD The disc is dirty or badly scratched. The unit cannot record, play, or edit. 73 The disc may be incompatible or of poor quality. 13, 14 You have used a lens cleaner and it has finished operation. Press[ OPEN/CLOSE] on the main unit to eject the disc.73, 75NoWRIT You cannot write to this disc.The disc may be damaged. Use a new disc.−FINAL When the screen asking if you want to finalise the disc appears, themessage is displayed.25PLEASE WAIT Displayed when the unit is started. This is not a malfunction. − The unit is carrying out its recovery process. You cannot operate the unitwhile the message is displayed.−PROG FULL There are already 16 timer recording programmes. Delete unnecessarytimer recording programmes.32PROTECT You have inserted a video cassette without the accidental erasureprevention tab. Use a video cassette with an accidental erasure preventiontab.74SW-DL The unit is performing a software update. 68UNSUPPORT You have inserted a disc the unit cannot play or record onto. 13, 14UNFORMAT You inserted an unformatted DVD-RAM, DVD-RW, +RW, an unused +R,+R DL or DVD-RW (DVD-Video format) that has been recorded on otherequipment.Format the disc to use it.However all the recorded contents on the disc are deleted.60F74 The HDMI connection could not be authenticated due to a transfermalfunction. Consult the dealer where the unit was purchased.−F75 The HDMI connection could not be authenticated due to an internal datamalfunction. Consult the dealer where the unit was purchased.−U59 The unit is hot.The unit switches to standby for safety reasons. Wait for about 30 minutesuntil the message disappears.Select a position with good ventilation when installing the unit. Do not blockthe cooling fan on the rear of the unit.−U61 (When a disc is not inserted) Displays when a malfunction has occurred.This is displayed when the unit is in the recovery process to return tonormal operation; it is not broken. Once the display disappears you can usethe unit again.− The message are alternately displayed.Messages