11.00 LockoutDescriptionIf the extension user remains off-hook after thecompletion of a call, he or she will bedisconnected from the channel after hearingreorder tone.Lockout applies to all types of calls:Extension,Intercom and CO line calls.ProgrammingNoneConditionsIf the extension user remains off-hook after thecompletion of a CO call on which “CPCDetection” has been set to “None,” reorder toneis not sent even if the other party, on the CO line,goes on-hook.Refer to Section 3-F-7.00 “Calling Party Control(CPC) Signal Detection” for further information.12.00Automatic Station ReleaseDescriptionIf an extension user fails to dial any digits within aspecified time period after getting a line formaking a call, he or she will be disconnectedfrom the channel after hearing reorder tone.To get a line for making a call again, theextension user must once go on-hook and thenoff-hook.When making an outgoing CO call with eitherPITS and SLT, the timers set by "System-Systemtimers", External First Digit Time-Out, ExternalInterdigit Time-Out and External Interdigit Time-Out (PBX) are used.ProgrammingConditionsThis function does not work when originating anintercom call or extension call with a PITS.This function works in the following cases whenoriginating a CO line call with a PITS.<1> When nothing has been dialed before theExternal First Digit Time-Out expires. Thistimer is started after CO dial tone has beenheard.<2> When the External Interdigit Time-Out hasexpired during dialing.This function works in the following cases whenoriginating a call with an SLT.<1> When the first digit was not dialed within 10seconds after dial tone was heard.<2> When the time between the digits beingdialed exceeds five seconds (only whenoriginating an extension call).System Programming ReferenceVT Dumb“System-System Timer ”,External First Digit Time-OutExternal Interdigit Time-OutExternal Interdigit Time-Out(PBX)10-C-6.009-D-3.003-B-21