INTEGRATING THE VPS WITH PANASONIC KX-T PHONE SYSTEMSInstallation Manual 493.3.2 KX-TA series Programming for Inband Integration via theManager’s Extension1. Enable System Programme [102] for each extension connected to the VPS. Jack 07, or jacks07 and 08 can be assigned for the VPS1 as the Voice Mail port. Jack 15, or jacks 15 and 16can be assigned for the VPS2.This parameter is used to tell the KX-TA series which extensions are connected to the VPS.Ports with this parameter enabled can receive Follow-on ID and touchtone call statusSignalling (busy, answered, disconnect, etc.) if the Voice Mail integration and TouchtoneIntegration features are also enabled.2. Enable System Programme [103] to turn on Touchtone Integration. On extensions with theVoice Mail port parameter enabled, the KX-TA series can send codes (touchtones) toindicate call states; this increases VPS efficiency. Codes apply to all transferred calls;outside calls only indicate disconnect (provided the KX-TA series is programmed for CPCDetection, and the Central Office sends the CPC signal). Refer to the Table 10 in Section3.2.4 PBX Interface Parameters.3. Put all extensions connected to the VPS into 1 extension group using System Programme[600].Reserve this extension group for these extensions! Do not mix other extensions into thisgroup.NoteUp to two VPS units can be connected to the KX-TA series. When two VPS units areconnected to the KX-TA series, 2 different extension groups should be assigned for eachCall WaitingSequence* N/A 1 N/A N/A 1 1 2ReleaseSequence forCall Waiting* N/A F N/A N/A F F F* Check with manufacturer.N/A Not Available(A) Adding "A" for "answer" to the operator and extension transfer eliminates the message:"You have a call" when the AA transfers a call. The VPS disconnects after line isanswered. Adding "D" for "disconnect" creates a blind transfer.Table 12PBX Type OtherManufacturersT308/T616T1232 T96 T336 TD816/TD1232TD308 TA series
