– "Not Specified": Bandwidth threshold notconsidered.– "256 kbps or more" – "2.0 Mbps ormore" (default: "768 kbps or more"): Considerbandwidth to determine the two types ofcommunication group thresholds.3. Press [G].• A dialogue box to confirm the saving of settingsis displayed.4. Use [ ][ ] to select "Yes" and press [ENTER].• The system settings screen is displayed.Setting One-touch ConnectionNumbersSet the addresses or profiles assigned to the one-touchconnection numbers (1 to 5) displayed on the homescreen.1. Select "One-Touch Set." and press [ENTER].• The one-touch connection number settingsscreen is displayed.2. Use [ ][ ] to select ""Not Registered"".3. Press [B].• A dialogue box is displayed for selecting whichkind of input method to reference.Note• When using a KX-VC1000 that has notbeen expanded for 4 Point Built-inMCU support, the contact list selectionscreen is displayed. Proceed to "When"Contact list" is selected:" in step 4.4. Use [ ][ ] to select the reference source,"Contact list" or "Profile" and press [ENTER].When "Contact list" is selected:The contact list selection screen is displayed.1. Use [ ][ ] to select the other party toregister, and press [ENTER].• The one-touch connection number settingsscreen is displayed.When "Profile" is selected:The profile list reference screen is displayed.1. Use [ ][ ] to select the group name you wantto register and press [ENTER].• The one-touch connection number settingsscreen is displayed.5. Press [G].• A dialogue box to confirm the saving of settingsis displayed.6. Use [ ][ ] to select "Yes" and press [ENTER].• The system settings screen is displayed.Making Screen StandbySettingsWhen the remote control is not operated or a videoconference call is not received for a specified length oftime, the unit enters standby mode. You can set thelength of time here.1. Select "Standby Setting" and press [ENTER].• The screen standby settings screen isdisplayed.2. Enter the length of time (0–99) in minutes until theunit enters screen standby mode (default: 10).Note• If you set "0", the unit will not enter screenstandby mode automatically. However, ifyou press the remote control’s[STANDBY] button, the unit will enterscreen standby mode even if "0" is set.3. Press [G].• A dialogue box to confirm the saving of settingsis displayed.4. Use [ ][ ] to select "Yes" and press [ENTER].• The system settings screen is displayed.Making Sound Settings1. Select "Sound Settings" and press [ENTER].• The sound settings screen is displayed.2. Use [ ][ ] to select the following items for input:"Welcome Screen Vol.": Press [ENTER] and use[ ][ ] to select the volume level ("OFF", "Low",Document Version 2018-01 User Manual 127Contacts and Settings
