Advanced42VQT0V63• The brightness of the pictures displayedon the LCD monitor is adjusted whenPower LCD mode or High angle mode isactivated. Therefore, some subjects maylook different on the LCD monitor.However, this does not affect the recordedpictures.• The LCD monitor automatically returns tonormal brightness after 30 seconds whenrecording in Power LCD mode. Press anybutton to make the LCD monitor brightagain.• You may not notice the High angle modeeffect if the LCD monitor is difficult to seebecause of light from the sun etc. shiningon it. In this case, we recommend usingyour hand or another object to block thelight when using the camera.• High angle mode is not activated in thefollowing cases.– In simple mode [ ]– In playback mode– While the menu screen is displayed– While the review screen is displayedTaking Pictures usingthe Built-in FlashA To open the flashPress the [ OPEN] button.B To close the flashPress the flash until it clicks.• Be sure to close the flash when not in use.• The flash setting is fixed to Forced OFF[ ] while the flash is closed.∫ Switching to the appropriate flashsettingSet the flash to match the recording.Press 1 [ ] to switch the flashsetting.• For information about flash settings thatcan be selected, refer to “Available flashsettings by recording mode”. (P43): AUTOThe flash is automatically activated whenthe recording conditions make it necessary.: AUTO/Red-eye reduction¢1The flash is automatically activated whenthe recording conditions make it necessary.It is activated once before the actualrecording to reduce the red-eyephenomenon (eyes of the subjectappearing red in the picture) and thenactivated again for the actual recording.OPEN
