Panasonic MICRO-IMAGECHECKER A200 Series Hardware Manual

Also see for MICRO-IMAGECHECKER A100 Series: Operating instructions Operating instructions

Contents

A200/A100 HardwareInput/Output Terminals (Input/Output Ports)3 − 83.5 Flash Output Sync Signal3.5 Flash Output Sync SignalTerminal PositionsCOMFLASHCOM: The flash terminal is locatedin the output terminal.FLASH: The common terminal for use bythe flash is a specializedterminal. Do not use it togetherwith other common lines.Output CircuitUse the output controller parallel output (NPN specification) circuit within the rangesillustrated below. (Maximum 24mA for 1 Signal)COM(–)OutputRated operating voltage:5 V to 24 V55Standard voltage: 5 V to 24 V DCExternally supplied power voltage (V)Currentload (mA)(±)Photo−mos controller output circuitOutputCOMRated operating voltage:5 V to 24 VNPN output controller output circuit Use within the range specified belowFlash Timing ChartFlash outputsignalAround 63μs(1H)550μs/450μsNPN output controller: A+B+C 550μsPhoto−Mos output controller: A+B+C 450μsA: Imagechecker flash output sync signal lag. Thisvalue changes depending on what type ofstrobe is attached.B: Strobe response time. Determined by thestrobe.C: Strobe flash time. Determined by the strobe.In the case on the NPN outputcontroller, use a flash for whichthe time from when the flashoutput synchronization signalgoes on to when the light gen-eration finishes is 550μs orless. For the Photo−MOS con-troller, use a flash for which thistime is 450μs or less.A strobe can only be used forthe flash output for theANM830A camera in framemode.OFF