Panasonic MICRO-IMAGECHECKER A200 Series Hardware Manual

Also see for MICRO-IMAGECHECKER A100 Series: Operating instructions Operating instructions

Contents

A200/A100 HardwareAbout Camera Modes5 − 45.2 Imaging Time for the Camera Modes (for memory image display) and Resolution5.2 Imaging Time for the Camera Modes (for memoryimage display) and ResolutionFrame FieldDouble−SpeedRa doImaging time = (shutter time) + 16.7ms Imaging time = (shutter time) + 8.3mspRandom16.7msShutter−timet= (Shutter−time) + (1/60s)Start TriggerShutter−timet= (Shutter−time) + (1/120s)Start Trigger8.3msResolution = 512 × 480 pixels Resolution = 512 × 240 pixelsSupports moving and still objects, continuouslight.Supports moving and still objects, continuouslightCamera = ANM831To switch between frame and field modes, you must change the settings on the controllermenu and change the DIP switch settings on the back of the camera. See note 1)Set the camera shutter speed from the controller menu.NormalI te al S cImaging time = 33.3 to 50ms Imaging time = 16.7 to 33.3msInternal SyncDelay−time=0 to16.7ms 33.3mst= (1/30s) to (1/20s)Start TriggerDelay−time=0 to 16.7ms 16.7mst= (1/60s) to (1/30s)Start TriggerResolution = 512 × 480 pixels Resolution = 512 × 240 pixelsSupports still objects and continuous light.Supports moving objects with strobe light thatuses the FLASH signal. See note 2)Supports moving and still objects, continuouslight.Camera = ANM832 See note 3)To switch between frame mode and field mode, change the settings on the controller menu.Set the camera shutter speed using the controller menu.1) See the information about DIP switches on page 1−6.2) When using a strobe light, set to normal frame mode, and be certain to switch the monitor display to“Memory Display”. If the monitor display is set to “Through Display”, the strobe will flash continuously.3) The internal sync is an NTSC signal input.