VCR Mode-35-To Search the tape position of a desiredpicture among the playback picturesdisplayed on 9 screens1 After displaying pictures in Multi-PictureMode, turn the [PUSH] Dial (38) to select theimage whose tape position you want tosearch.≥The selected picture is marked with a frame.2 Press the [:] or [9] Button (61) on theRemote Controller.≥A still picture playback takes place at theselected picture.≥For other notes concerning this item, see -57-.Playing Back on Your TVBy connecting your Movie Camera with your TV,the recorded scenes can be viewed on your TVscreen.≥Before connecting them, turn off the power ofboth the Movie Camera and TV.1 Connect the [AV IN/OUT] Socket of theMovie Camera and the Video and AudioInput Sockets of the TV.≥Using the AV Cable 1, make a connectionwith the TV. If the TV has an S-Video Socket,connect the S-Video Cable 2, too.PUSHMF/VOL/JOGWB/SHUTTER/IRIS/(38)INDEX INDEXSELECTSTOPK L∫V/REWSTILL ADVWsVPLAYPAUSEFF/WSTILL ADV6 1 5;E D(61) (61)21-pin AdaptorS-VIDEOIN/OUT12[VIDEO IN][AUDIO IN][S-VIDEO IN]AV IN/OUTPHONES REMOTE/MIC(PLUG IN POWER)≥When plugging the pin plug of the AV cableinto the [AV IN/OUT] Socket, plug it in as faras it goes.To Make the Indications Appear on the TVScreenPress the [OSD] Button (54) on the RemoteController.≥If your TV is not equipped with AV InputSockets, the 21-pin Adaptor (purchaseseparately) is necessary. Consult your dealer.≥For other notes concerning this item, see -58-.Audio DubbingYou can add music or narration to the recordedCassette.≥If the tape recorded in the [16bit] Mode isdubbed with the Audio Dubbing function, theoriginal sound is erased. (If you wish topreserve the original sound, use the [12bit]Mode when recording.)≥Audio Dubbing cannot be performed on arecording done in LP Mode. (-17-)1 Set [VCR FUNCTIONS] >>[AV IN/OUT SETUP] >> [AV JACK] >>[IN/OUT]. (NV-GS50 only)2 Continuing the aforesaid setup, select[A.DUB INPUT] >> [MIC] or [AV IN].(NV-GS50 only)≥Set to [AV IN] when external device is used,and to [MIC] when an external or built-inmicrophone is used.3 Press the [;] Button (72) on the RemoteController where you want to add newsound.4 Press the [A.DUB] Button (58) on theRemote Controller.5 To start Audio Dubbing, press the [;]Button (72) on the Remote Controller.OSD DATE/TIME PHOTOSHOTSTART/STOP(54)MENUPUSHMF/VOL/JOGWB/SHUTTER/IRIS/(46) (38)INDEX INDEXSELECTSTOPK L∫V/REWSTILL ADVTWsVOLr¥RECMULTI/P-IN-P A.DUBPLAYPAUSEFF/WSTILL ADV6 1 5;E D(58)(72)