CARD Mode-38-CARD ModeUsing a CardA Card can be used to record still pictures.≥Use genuine Card only.ª Inserting a CardBefore inserting a Card, be sure to turn off theMovie Camera.1 Slide the [OPEN] Lever (4) to open the CardSlot Cover (5).2 While holding the Memory Card with its cutcorner facing right 1, insert it into the CardSlot (6).3 Close the Card Slot Cover (5) securely.Removing the CardOpen the Card Slot Cover and press the centre ofthe Card and then pull it straight out.≥After removing the Card, close the Card SlotCover.≥The Movie Camera may be damaged if theCard is forced out when the Card is fullyinserted.ª [ACCESS] Lamp (3)While the Movie Camera is making an access tothe Card (reading, recording, playback, erasing ormoving of images), the [ACCESS] Lamp lightsup.≥While the [ACCESS] Lamp is on, never attemptto open the Card Slot Cover, to pull out theCard, to turn off the Movie Camera, or to switchthe [TAPE/CARD/CARD MODE] Selector. Suchactions will damage the Card, cause loss ofrecorded data and cause the Movie Camera tomalfunction.OPEN(4) (5)1(6)ACCESS(3)Recording on a Card3 kinds of data can be recorded by selecting withthe [TAPE/CARD/CARD MODE] Selector (27).When recording picture, slide the[TAPE/CARD/CARD MODE] Selector until the[PICTURE] Indication 1 appears (CardPhotoshot), when recording moving picture, slidethe [TAPE/CARD/CARD MODE] Selector untilthe [MPEG4] Indication 2 appears (MPEG4Recording), when recording voice, slide the[TAPE/CARD/CARD MODE] Selector until the[VOICE] Indication 3 appears (Voice Recording).≥If the [TAPE/CARD/CARD MODE] Selector (27)is set to [CARD] with a Card inserted, the MovieCamera is automatically turned off when youleave it for about 6 minutes without performingany recording.≥When the [TAPE/CARD/CARD MODE] Selector(27) is set to [CARD], you cannot record to theTape.ª Card PhotoshotStill pictures can be recorded on the MemoryCard from the Movie Camera lens as well as fromscenes that have already been recorded on acassette.Recording from the Movie Camera Lens(CAMERA Mode)1 Set the [TAPE/CARD/CARD MODE] Selector(27) to [CARD].PICTURE1MPEG42VOICE3TAPE CARD CARDMODE(27)TAPE CARD CARDMODE(27)