Panasonic NV-GS40 Operating Instructions Manual

Contents

Before Use-9-3 Insert the Battery Holder into the RemoteController.≥When the button-type battery is exhausted,replace it with a new CR2025 battery. (A batteryis normally expected to last about 1 year.However, it depends on operation frequency.)≥Make sure to match the poles correctly wheninserting the battery.ª Using the Remote Controller1 Direct the Remote Controller to the RemoteControl Sensor (35) of the Movie Cameraand press an appropriate button.≥Distance from the Movie Camera: Withinapproximately 5 metres≥Angle: Within approximately 15o in thevertical and horizontal directions from thecentral axisWARNING“THE LITHIUM BATTERY IS A CRITICALCOMPONENT (TYPE NUMBER CR2025MANUFACTURED BY PANASONIC).IT MUST NEVER BE SUBJECTED TOEXCESSIVE HEAT OR DISCHARGE. ITMUST THEREFORE ONLY BE FITTED INEQUIPMENT DESIGNED SPECIFICALLYFOR ITS USE.REPLACEMENT BATTERIES MUST BE OFTHE SAME TYPE AND MANUFACTURER.THEY MUST BE FITTED IN THE SAMEMANNER AND LOCATION AS THEORIGINAL BATTERY, WITH THECORRECT POLARITY CONNECTIONSOBSERVED.DO NOT ATTEMPT TO RE-CHARGE THEOLD BATTERY OR RE-USE IT FOR ANYOTHER PURPOSE. IT SHOULD BEDISPOSED OF IN WASTE PRODUCTSDESTINED FOR BURIAL RATHER THANINCINERATION.”15˚15˚15˚15˚ (35)≥The above operative ranges are for indoor use.Outdoors or under strong light, the MovieCamera may not operate properly even withinthe above ranges.≥Within a 1-metre range, you can also use theRemote Controller on the LCD Monitor side ofthe Movie Camera.Selecting Remote Controller ModesWhen 2 Movie Cameras are usedsimultaneously, they can be operated individuallyby selecting different Remote Controller Modes.≥If the Remote Controller Mode of the MovieCamera and that of the Remote Controller donot match, [REMOTE] Indication is displayed.Setup on the Movie Camera:Set [REMOTE] on the [OTHER FUNCTIONS]Sub-Menu to the desired Remote ControllerMode. (-15-)Setup on the Remote Controller:[VCR1]:Press the [D] Button and [∫] Buttonsimultaneously. 1[VCR2]:Press the [E] Button and [∫] Buttonsimultaneously. 2≥When the battery in the Remote Controller isreplaced, the mode is automatically reset to[VCR1] Mode.Power Supplyª Using the AC Adaptor1 Connect the DC Input Lead to the MovieCamera.2 Connect the DC Input Lead to the ACAdaptor.INDEX INDEXSELECTSTOPK L∫STILL ADVTWPAUSE STILL ADV6 1 5;E D2 11