|
22 - ENGLISHChapter 1 Preparation — About your projectorrr Control panel91011121314123456781 Power standby <v> buttonSets the projector to the standby mode when the POWER> switch on the projector is set to .2 Power on <b> buttonStarts projection when the switch on theprojector is set to when the power is switched off (standbymode).3 Switches to VIDEO input.4 buttonSwitches to S-VIDEO input.5 buttonSwitches to RGB1 input.6 buttonSwitches to RGB2 input.7 buttonSwitches to DVI-D input.8 buttonSwitches to HDMI input.9 Displays and erases the main menu.Returns to the previous screen when a sub-menu is displayed.(x page 51)If you press the least three seconds while the on-screen indication is off, the on-screen display is turned on.10 buttonAdjusts the focus, zoom, and shift (position) of the lens.11 buttonDetermines and executes an item in the menu screen.12 buttonUse to temporarily turn off the image. (x page 47)13 asqw selection buttonsUse to select items in the menu screen, change settings, andadjust levels.It is also used to enter [SECURITY] passwords.14 buttonAutomatically adjusts the image display position while projectingthe image.[PROGRESS] is displayed on the screen while the image isadjusted automatically. (x page 48)rr Connecting terminals1 2 3 4 5 67 8 9 10 111 terminalThis is a terminal to connect to the network.Used for control and monitoring. Image input through networkconnections is not possible.2 This is a terminal to input video signals.3 terminalThis is a terminal to input S video signals.4 ( R >, , B >, , )terminalThis is a terminal to input RGB signals or YCBC R /YPBPR signals.5 terminalThis is a terminal to input HDMI signals.6 terminalThis is a terminal to input DVI-D signals.7 terminal / terminalThese are the terminals to connect the remote control for serialcontrol when the system uses multiple projectors.8 terminalThis is a terminal to remotely control the projector using theexternal control circuit.9 terminalThis is a RS-232C compatible terminal to externally control theprojector by connecting a computer.10 terminalThis is a terminal to output the signal connected to the serialinput terminal.11 terminalThis is a terminal to input RGB signals or YCB C R /YPBPR signals.Attentionrf When a LAN cable is directly connected to the projector, the network connection must be made indoors.
|
