42 - ENGLISHChapter 3 Basic Operation — Switching on/off the projectorPower indicatorDisplays the status of the power. Check the status of the power indicator before operating the projector.Power indicator G /STANDBYR >Indicator status StatusNo illumination or flashing The main power is switched off.Red LitThe power is switched off. (Standby mode.)Projection will start if the power on <b> button is pressed.rf The projector may not operate when the lamp indicators / ortemperature indicator is flashing. (x page 110)Green Lit Projecting.Orange Lit The projector is preparing to switch off the power.The power is switched off after a while. (Changes to the standby mode.)Noterf When the power indicator lamp is lit in orange, the fan is turning and the projector is cooling.rf The projector consumes power even in standby mode (power indicator is lit in red).Refer to “Power consumption” (x page 128) for the power consumption.rf The power indicator will flash in green if a remote control signal is received.rf The power indicator will flash slowly in green while the shutter is closed. (x page 47)rf If the power indicator is flashing in red, consult your dealer.Switching on the projector3)3)2) 1)To use a projection lens that is an optional accessory, attach the lens before switching on the projector. (x page 35)Remove the lens cover first.1) Connect the power plug to an outlet.rf (AC 220 V - 240 V 50 Hz/60 Hz)2) Press the side of the switch to turn on the power.rf The power indicator will light in red,and the projector will enter the standby mode.3) Press the power on <b> button.rf The power indicator will light in greenand the image will soon be projected on the screen.Noterf If the projector is switched on at about 0°C (32°F), a warm-up period of approximately five minutes may be necessary until a projection isdisplayed.The temperature indicator is lit during the warm-up period. When the warm-up is completed, the temperature indicator turns off and the projection starts. Refer to “Managing the indicated problems” (x page 110) for the indicator status.rf If the operating environment temperature is low and warm-up takes more than 5 minutes, the projector will judge that a problem hasoccurred and the power will automatically be set to stand-by. If this happens, increase the operating environment temperature to 0°C (32°F)
