ENGLISH - 79Chapter 4 Settings — [PROJECTOR SETUP] menu9) Press qw to switch [COMMAND].rf The setting will change among [POWER ON], [STANDBY],[SHUTTER] *1 , [INPUT]*1 , [LAMP SELECT]*1 , [LAMP POWER]*1and [SIDE BY SIDE]*1*2 each time you press the button.*1 The details set in step 11) are displayed.*2 Only for PT-DW740E10) Press the button.rf The [COMMAND] detailed screen is displayed.11) Press as to select a command.rf [OPEN]/[CLOSE] in [SHUTTER], [RGB1]/[RGB2]/[VIDEO]/[S-VIDEO]/[DVI-D]/[HDMI] in [INPUT], [DUAL]/[SINGLE] in[LAMP SELECT], [NORMAL]/[ECO] in [LAMP POWER], and[OFF]/[ON] in [SIDE BY SIDE] will change each time you pressqw.12) Press the button.rf The command is fixed and ● is displayed at the left of theselected command.rf After the command is fixed, press the the detailed setting menu.13) Press as to select [STORE], and press the button.rr [COMMAND][POWER ON] ― Turns the power on.[STANDBY] ― Enters standby.[SHUTTER] [OPEN] Opens the shutter.[CLOSE] Closes the shutter.[INPUT][RGB1] Switches the input to RGB1.[RGB2] Switches the input to RGB2.[VIDEO] Switches the input to VIDEO.[S-VIDEO] Switches the input to S-VIDEO.[DVI-D] Switches the input to DVI-D.[HDMI] Switches the input to HDMI.[LAMP SELECT][DUAL] Turns on both lamps.[SINGLE] Turns on one lamp. (The lamp is automatically selected which has shortercumulative operating time.)[LAMP POWER] [NORMAL] Sets the high luminance of the lamp.[ECO] Sets lower luminance of the lamp than [NORMAL].[SIDE BY SIDE] * [OFF] Displays the side-by-side screen.[ON] Cancels the side-by-side screen.* Only for PT-DW740ENoterf If you try to register a setting that would cause the lamp to flash for a short time, an error message will be displayed on the screen. Set thetime and command again.rf To delete a command already set, press the button on the Step 5) screen, or select [DELETE] on the Step 6) screen and pressthe button.rf If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest commandnumber.rf The operating time will be the local time. (x page 83)rf If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in[SCHEDULE] is executed, the command set with this function may not be executed.[STARTUP INPUT SELECT]Set the input signal to be projected when the projector is switched on.1) Press as to select [STARTUP INPUTSELECT].2) Press qw to switch [STARTUP INPUTSELECT].rf The setting will change among [LAST USED], [RGB1], [RGB2],[VIDEO], [S-VIDEO], [DVI-D] and [HDMI] each time you pressthe button.rr [STARTUP INPUT SELECT][LAST USED] Keeps the input selected last.[RGB1] Sets the input to be projected when the projector is switched on to RGB1.[RGB2] Sets the input to be projected when the projector is switched on to RGB2.[VIDEO] Sets the input to be projected when the projector is switched on to VIDEO.
