78 - ENGLISHChapter 4 Settings — [PROJECTOR SETUP] menuNoterf When [ECO] is set, the power consumption and operation sound can be reduced while the lamp life can be increased.[STANDBY MODE]Set the power consumption during the standby.1) Press as to select [STANDBY MODE]. 2) Press qw to switch [STANDBY MODE].rf The setting will change between [NORMAL] and [ECO] eachtime you press the button.rr [STANDBY MODE][NORMAL] Normally use this setting.[ECO] Use this setting to reduce power consumption during standby.Noterf When set to [ECO], network functions and terminal are not available during standby. Also, some RS-232C commands arenot available. When set to [NORMAL], network functions and terminal are available during standby.rf When set to [ECO], display may delay about 10 seconds when the power is turned on, compared to the [NORMAL] setting.[SCHEDULE]Set the command execution schedule for each day of the week.Enabling/disabling the schedule function1) Press as to select [SCHEDULE]. 2) Press qw to switch [SCHEDULE].rf The setting will change between [OFF] and [ON] each time youpress the button.rr [SCHEDULE][OFF] Disables the schedule function.[ON] Enables the schedule function. Refer to “How to assign a program” (x page 78) or “How to set aprogram” (x page 78) in regard to how to set the schedule.Noterf When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].How to assign a program1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.rf The [SCHEDULE] screen is displayed.3) Select and assign program to each day ofweek.rf Press as to select the day of week, and press qw to select aprogram number.rf You can set the program from No.1 to No.7. “- - -” indicates thatthe program number has not been set yet.How to set a programYou can set up to 16 commands to each program.1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.rf The [SCHEDULE] screen is displayed.3) Press as to select [PROGRAM EDIT].4) Press qw to select a program number andthen press the button.5) Press as to select a command number andpress the button.rf You can change the page using qw.6) Press as to select [TIME], and press the button.7) Press qw to select hour and minute, and pressas or the number (<0> to <9>) buttons to seta time, and press the button.8) Press as to select [COMMAND].
