Start-up display18 - ENGLISHPreparationStart-up displayThe initial setting screen is displayed when the projector is switched on for the first time after purchase as well aswhen [INITIALIZE] – [ALL USER DATA] ( page 74) is executed. Set them in accordance with circumstances.In other occasions, you can change the settings by menu operations.Notez When the projector is used for the first time, you may be required to adjust the focus, zoom, and shift to displaythe menu screen clearly.Refer to “Adjusting the focus, zoom, and shift” ( page 39) for details.▶■ Initial setting (display language)Select the language to show on the screen.( page 57)1) Press ▲▼ to select the displaylanguage.(17(5,1,7,$/6(77,1*3/($6(6(/(&7/$1*8$*(6(/(&76(72) Press the button to proceedto the initial setting.▶■ Initial setting (projector setup)Set each item.1) Press ▲▼ to select an item.2) Press ◀▶ to switch the setting.ENTER16㧦10SWITCH TO HIGH ALTITUDE MODE "ON"IF OVER 1400m (4593Ft).MENU SELECT CHANGESETINITIAL SETTINGPROJECTION METHODCOOLING CONDITIONSCREEN FORMATSCREEN POSITIONHIGH ALTITUDE MODEFRONT/FLOORFLOOR SETTINGOFFRefer to the following page for details of eachitem.▶z [PROJECTION METHOD] ( page 66)▶z [COOLING CONDITION] ( page 67)▶z [SCREEN FORMAT] ( page 60)▶z [SCREEN POSITION] ( page 60)▶z [HIGH ALTITUDE MODE] ( page 67)3) Press the button.▶z Confirm the setting value to complete the initialsetting.Notez If you press the (projector setup) screen, you can go back to theinitial setting (display language) screen.
