[PICTURE] menu48 - ENGLISHSettings[COLOR]You can adjust the color saturation of the projectedimage.1) Press ▲▼ to select [COLOR].2) Press ◀▶ or the button.▶z The [COLOR] individual adjustment screen isdisplayed.3) Press ◀▶ to adjust the level.Operation Adjustment RangePress ▶ . Deepens colors. Maximumvalue +31Press ◀ . Weakens colors. Minimumvalue –31[TINT]You can adjust the skin tone in the projected image.1) Press ▲▼ to select [TINT].2) Press ◀▶ or the button.▶z The [TINT] individual adjustment screen isdisplayed.3) Press ◀▶ to adjust the level.Operation Adjustment RangePress ▶ .Adjusts skin tonetoward greenishcolor.Maximumvalue +31Press ◀ .Adjusts skin tonetoward reddishpurple.Minimumvalue –31[COLOR TEMPERATURE]You can switch the color temperature if the whiteareas of the projected image are bluish or reddish.1) Press ▲▼ to select [COLORTEMPERATURE].2) Press ◀▶ or the button.▶z The [COLOR TEMPERATURE] individualadjustment screen is displayed.3) Press ◀▶ to switch [COLORTEMPERATURE].▶z The setting will change as follows each timeyou press the button.[DEFAULT] [USER][HIGH] [MIDDLE]Notez When [COLOR MATCHING] ( page 58)adjustment is set to other than [OFF], [COLORTEMPERATURE] is fixed to [USER].▶■ To adjust desired white balance4) Select [USER] in Step 3).5) Press the button.▶z The [COLOR TEMPERATURE] screen isdisplayed.6) Press ▲▼ to select [WHITEBALANCE].7) Press the button.▶z The [WHITE BALANCE] screen is displayed.8) Press ▲▼ to select [WHITE BALANCEHIGH] or [WHITE BALANCE LOW].9) Press the button.▶z The [WHITE BALANCE HIGH] screen or the[WHITE BALANCE LOW] screen is displayed.10) Press ▲▼ to select [RED][GREEN][BLUE].11) Press ◀▶ to adjust the level.Item Operation Adjustment Range[RED]Press ▶ . Deepensred.MaximumvalueHigh: 255Low: 63Press ◀ . Weakensred.[GREEN]Press ▶ . Deepensgreen.MinimumvalueHigh: 0Low: 0Press ◀ . Weakensgreen.[BLUE]Press ▶ . Deepensblue. DefaultHigh: 255Low: 32Press ◀ . Weakensblue.Notez Adjust [COLOR TEMPERATURE] correctly. Allcolors will not be displayed properly unless adequateadjustment is made. If the adjustment does not looksuitable, you can press the buttonon the remote control to return the setting for theselected item only to the factory default setting.z The setting of [COLOR TEMPERATURE] is notreflected in internal test patterns ( page 75).Make sure to set [COLOR TEMPERATURE] whileprojecting input signal.▶■ To change the [USER] name4) Select [USER] in Step 3).5) Press the button.▶z The [COLOR TEMPERATURE] screen isdisplayed.6) Press ▲▼ to select [COLORTEMPERATURE NAME CHANGE].
