[SECURITY] menuENGLISH - 79 Settings[SECURITY] menuSelect [SECURITY] from the main menu, andselect the item from the sub-menu.Refer to “Navigating through the menu”( page 44) for the operation of the menuscreen.z When the projector is used for the first timeInitial password: Press ▲▶▼◀▲▶▼◀ inorder, and press the button.z After selecting the item, press ▲▼◀▶ to set.Attentionz When you select the [SECURITY] from the mainmenu and press the button, entering apassword is required. Enter the set password andthen continue operations of the [SECURITY] menu.z When the password has been changed previously,enter the changed password, and press the button.Notez The entered password is displayed with * mark onthe screen.[SECURITY PASSWORD]The [SECURITY PASSWORD] screen is displayedwhen the power is turned on. When the enteredpassword is incorrect, the operation will be restrictedto the power standby < > button, the button, and the (, , and) buttons.1) Press ▲▼ to select [SECURITYPASSWORD].2) Press ◀▶ to switch [SECURITYPASSWORD].▶z The setting will change as follows each timeyou press the button.[OFF] [ON][OFF] Disables the security password entry.[ON] Enables the security password entry.Notez The [SECURITY PASSWORD] setting is set to[OFF] at the time of purchase or when all the userdata has been initialized.z Change the password periodically that is hard toguess.z The security password will be enabled after setting[SECURITY PASSWORD] to [ON] and turning the switch to .[SECURITY PASSWORDCHANGE]Change the security password.1) Press ▲▼ to select [SECURITYPASSWORD CHANGE].2) Press the button.▶z The [SECURITY PASSWORD CHANGE]screen is displayed.3) Press ▲▼◀▶ and the number (<0> to<9>) buttons to set the password.▶z Up to eight button operations can be set.4) Press the button.5) Re-enter the password for theconfirmation.6) Press the button.Notez The entered password is displayed with * mark onthe screen.z An error message is displayed on the screen whenthe entered password is incorrect. Re-enter thecorrect password.[DISPLAY SETTING]Overlap the security message (text or image) over theprojecting image.1) Press ▲▼ to select [DISPLAYSETTING].2) Press ◀▶ to switch [DISPLAYSETTING].▶z The setting will change as follows each timeyou press the button.[OFF] [TEXT] [USER LOGO][OFF] The text display is disabled.[TEXT] The text display is enabled.[USER LOGO] The picture registered by the useris projected.Notez To create the image for [USER LOGO], “LogoTransfer Software” included in the supplied CD-ROM is required.
