Panasonic PT-DZ770E Operating Instructions Manual

Contents

[ADVANCED MENU]54 - ENGLISHSettingsSelect [ADVANCED MENU] from the mainmenu, and select the item from the sub-menu.Refer to “Navigating through the menu”( page 44) for the operation of the menuscreen.z After selecting the item, press ▲▼◀▶ to set.[DIGITAL CINEMA REALITY]You can increase the vertical resolution and enhancethe picture quality by performing the cinemaprocessing when the PAL (or the SECAM) 576i signal,the NTSC 480i, 1080/50i, and 1080/60i signals areinput.1) Press ▲▼ to select [DIGITAL CINEMAREALITY].2) Press ◀▶ to switch [DIGITAL CINEMAREALITY].▶z The setting will change as follows each timeyou press the button.[AUTO] [OFF][25p FIXED](when a 576i or 1080/50i signal is input)[30p FIXED](when a 480i or 1080/60i signal is input)[AUTO]Performs automatic detection andcinema processing.(Factory default)[OFF] Unforced cinema processing.[25p FIXED]Forced cinema processing(2:2 pulldown) is performed when a576i or 1080/50i signal is input.[30p FIXED]Forced cinema processing(2:2 pulldown) is performed when a480i or 1080/60i signal is input.Notez When a signal other than a 2:2 pulled-down signalis set to [25p FIXED] or [30p FIXED] in [DIGITALCINEMA REALITY], picture quality deteriorates.(Vertical resolution will degrade.)[BLANKING]The blanking width is adjusted when there are noiseat the edge of the screen or the image is slightlyrunning out from the screen when an image from theVCR or other devices are projected.1) Press ▲▼ to select [BLANKING].2) Press the button.▶z The [BLANKING] adjustment screen isdisplayed.3) Press ▲▼ to select the adjustmentitem.4) Press ◀▶ to adjust the blanking.▶z Adjustment values will change between 0 and959 for left and right, and between 0 and 599for top and bottom.When correcting blanking at the top of the screen[UPPER]Press ◀ to move theblanking zone upward.Press ▶ to move theblanking zone downward.When correcting blanking at the bottom of thescreen [LOWER]Press ▶ to move theblanking zone upward.Press ◀ to move theblanking zone downward.When correcting blanking at the left of the screen[LEFT]Press ▶ to move theblanking zone to the right.Press ◀ to move theblanking zone to the left.When correcting blanking at the right of thescreen [RIGHT]Press ◀ to move theblanking zone to the right.Press ▶ to move theblanking zone to the left.[ADVANCED MENU]