Panasonic PT-EZ770Z Operating Instructions Manual

Also see for PT-EW730Z: Information for users Service manual Operating instructions Operating instructions

Contents

Panasonic PT-EZ770Z Operating Instructions Manual Manual pdf 49 page image

Chapter 3 Basic Operations — Switching on/off the projectorENGLISH - 492) Change the setting of [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on theinstallation mode. (x page 33)f Refer to “Navigating through the menu” (x page 59) for the operation of the menu screen.3) Press the button on the control panel or the input selection (, ,

4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 40)5) Press the button to adjust the position of the image.6) If the input signal is an RGB signal, press the button.7) Press the button to adjust the size of the image to match the screen.8) Press the button again to adjust the focus.9) Press the button again to adjust the zoom and the size of the image to match the screen.Notef When the projector is switched on for the first time after purchase as well as when [ALL USER DATA] in the [PROJECTOR SETUP] menu →[INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen is displayed. Refer to“Start-up display” (x page 24) for details.Switching off the projector1)2)1)4)3)2)1) Press the power <v/b> button on the control panel or the power standby <v> button on the remotecontrol.f The [POWER OFF(STANDBY)] confirmation screen is displayed.2) Press qw to select [OK], and press the button.(Or press the power <v/b> button on the control panel or the power standby <v> button on theremote control again.)f Projection of the image will stop, and the power indicator on the projector body lights in orange. (The fankeeps running.)3) Wait for about 100 seconds until the power indicator on the projector bodylights in red.4) Press the side of the

switch to turn off the power.Notef Do not switch on the projector and project images immediately after switching off the projector.Turning on the power while the lamp is still hot may shorten the lamp life.f For about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp indicators will not light up evenif the power is switched on. Even after 75 seconds, the lamp may not light up if the projector is switched on. In such a case, after the powerindicator lights in red, switch on the projector again.f The projector consumes power even when the power <v/b> button on the control panel or the power standby <v> button on theremote control is pressed and the projector is switched off if the main power of the projector is on.When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is restricted,but the power consumption during standby can be conserved.