Chapter 4 Settings — [PROJECTOR SETUP] menu90 - ENGLISHSetting [NO SIGNAL SHUT-OFF]A function that automatically switches the power of the projector to standby if there is no input signal for a certain period of time. The timebefore switching to standby can be set.1) Press as to select [ECO MANAGEMENT].2) Press the button.f The [ECO MANAGEMENT] screen is displayed.3) Press as to select [NO SIGNAL SHUT-OFF].4) Press qw to switch the item.f The items will switch each time you press the button.[DISABLE] Disables the No signal shut-off function.[10MIN.] - [90MIN.] Allows you to set in ten minutes intervals.Setting [STANDBY MODE]Set the power consumption during the standby.1) Press as to select [ECO MANAGEMENT].2) Press the button.f The [ECO MANAGEMENT] screen is displayed.3) Press as to select [STANDBY MODE].4) Press qw to switch the item.f The items will switch each time you press the button.[ECO] Use this setting to reduce power consumption during standby.[NORMAL] Use this setting to use the network function during standby.Notef When [ECO] is set, the network function and some RS-232C commands become inoperable during standby. When [NORMAL] is set, thenetwork function becomes operable during standby.f When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared withwhen [NORMAL] is set.f The [STANDBY MODE] settings are not reset to their factory defaults when [ALL USER DATA] in [PROJECTOR SETUP] menu →[INITIALIZE] (x page 98) is executed.[SCHEDULE]Set the command execution schedule for each day of the week.Enabling/disabling the schedule function1) Press as to select [SCHEDULE].2) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Disables the schedule function.[ON] Enables the schedule function. Refer to “How to assign a program” (x page 90) or “How to set aprogram” (x page 91) for how to set the schedule.Notef When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].How to assign a program1) Press as to select [SCHEDULE].
