Panasonic PT-LW362 Operating Instructions Manual

Also see for PT-LB332: Operating instructions (functional manual)

Contents

Panasonic PT-LW362 Operating Instructions Manual Manual pdf 64 page image

64 - ENGLISHItems Operation Adjustment[Curvedcorrection XOffset]Press the w button.Used to correct the right side vertical lines.Extend the top and bottom while keepingthe center part as it is.Press the q button.Used to correct the left side vertical lines.Extend the top and bottom while keepingthe center part as it is.Press the a button.Used to correct the both sides of the verticallines. Extend the lower corners whilekeeping the center part and the upper partas they are.Press the s button.Used to correct the both sides of the verticallines. Extend the top corners while keepingthe center part and the lower part as theyare.[Curvedcorrection YOffset]Press the w button.Used to correct the right side horizontallines. Extend the top and bottom whilekeeping the center part as it is.Press the q button.Used to correct the left side horizontal lines.Extend the top and bottom while keepingthe center part as it is.Press the a button.Used to correct the both sides of thehorizontal lines. Extend the lower cornerswhile keeping the center part and the upperpart as they are.Press the s button.Used to correct the both sides of thehorizontal lines. Extend the top cornerswhile keeping the center part and the lowerpart as they are.Notef Either [H/V Keystone] or [Corner correction] setting value is valid. If the other item is adjusted after [H/V Keystone] or [Cornercorrection] was adjusted, the previous setting value will be reset.f The [Curved correction X Offset] and the [Curved correction Y Offset] cannot be adjusted independently. After adjusting the[Curved correction X/Y Gain] at the beginning, please adjust the [Curved correction X Offset] and the [Curved correction YOffset].f Press the button on the control panel or on the remote control when the [H/V Keystone], [Corner correction]or [Curved correction] individual adjustment screen is displaying, the individual adjustment screen will switch as follows.- [H/V Keystone]  [Corner correction] (Upper left)  [Corner correction] (Upper right)  [Corner correction] (Lower right) [Corner correction] (Lower left)  [Curved correction X/Y Gain]  [Curved correction X Offset]  [Curved correction YOffset]  [H/V Keystone]  ...f Correcting up to ±30° for the tilt in the vertical direction and ±15° for the tilt in the horizontal direction are available foradjustments with [Keystone]. However, the image quality will degrade and it will get harder to focus with more correction.Install the projector so that the correction will be as small as possible.f Screen size will also change when [H/V Keystone] is used to perform various adjustments.f Aspect ratio of the image size may shift depending on the correction.Resetting the keystone correctionTo return to the factory default state by releasing the state of the keystone correction.1) Press as to select [Keystone].2) Press the button.f The [Keystone] screen is displayed.3) Press as to select [Reset value].4) Press the button.f The state of the keystone correction is released.[Logo]This function allows you to set the Logo select, the image capturing and the Logo PIN code.1) Press as to select [Logo].2) Press the button.f The [Logo] screen is displayed.Chapter 4 Settings - [Expand] menu