ENGLISH - 714) Press the button.f [Remote control] is set.Notef To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified by remote control. Ifmultiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors withother ID numbers.f Refer to “Setting the remote control ID numbers” (x page 43) for how to set the ID number on the remote control.[Factory default]Return various setting values to their factory default settings.1) Press as to select [Factory default].2) Press the button.f The [Return to Factory default?] screen is displayed.3) Press as to select [Yes] and then press the button.f The [OK?] screen is displayed.4) Press as to select [Yes] and then press the button.f The [Please wait] message will appear, and resetting operation will start, and after completing the operation, the[Please wait] message will disappear.Attentionf After executing the [Factory default], be sure to turn off the projector (x page 37), disconnect the power plug from the walloutlet, and then turn on the projector in order to reflect the initial setting values.Notef When [Factory default] is executed, all setting values except for User Logo, PIN code lock, Logo PIN code lock, Lampcounter, Filter counter and Logo select will be returned to the factory default settings.Chapter 4 Settings - [Expand] menu
