Panasonic PT-VX42Z Operating Instructions Manual

Also see for PT-VX42Z: Operating instructions (functional manual)Manual 

Contents

Panasonic PT-VX42Z Operating Instructions Manual Manual pdf 24 page image

Using the remote controlInserting and Removing batteriesOpen the cover. (Fig. 1)1)Insert batteries and close the cover (Insert the2) m side first.) (Fig. 2)When removing the batteries, perform the steps in reverse order.fSetting Remote control ID numbersWhen you use the system with multiple projectors, you can operate all the projectors simultaneously or each projectorindividually using single remote control, if unique ID number is assigned to each projector.After setting the ID number of the projector, set the same ID number to the remote control.The factory default ID number of the projector is set to [ALL]. When using a single projector, press the button on the remote control. Also, you can control a projector by pressing the button on the remote controleven if you do not know the projector ID.How to setPress the button on the remote control.1)Within five seconds, press the one digit ID number set on the projector using the number (<1> - <6>)2)buttons.If you press the button, you can control the projectors regardless of the ID number setting of the projector.fAttentionSince the ID number of the remote control can be set without the projector, do not press the button on the remotefcontrol carelessly. If the button is pressed and no number (<1> - <6>) buttons are pressed within five seconds, theID number returns to its original value before the button was pressed.The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote controlfis left with dead batteries. Set the same ID number again when the batteries are replaced.NoteSet the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID]. (f Æpage 66)Fig. 1 Fig. 224 - ENGLISHChapter 1 Preparation - Using the remote control