|
[AUTO SETUP SETTING]Set the automatic execution of AUTO SETUP.The screen display position or signal level can be adjusted automatically without pressing the button on theremote control or the control panel on each occasion if you input unregistered signals frequently at meetings, etc.Press1) as to select [AUTO SETUP SETTING].Press2) qw to switch the item.The items will switch each time you press the button.f[AUTO] Enables the auto setup function when switching signals.[BUTTON] Enables the auto setup function only when the button is pressed.[SIGNAL SEARCH]When the power is turned on, this function automatically detects the terminal which signals are input and sets the function toswitch.Press1) as to select [SIGNAL SEARCH].Press2) qw to switch the item.The items will switch each time you press the button.f[ON] Enables input detection automatically.[OFF] Disables input detection automatically.NoteIf the [SIGNAL SEARCH] is set to [ON] when there is no signal input, press the button on the remotefcontrol or the control panel, this function automatically detects the terminal to which signals are input and then switches.[BACK COLOR]Set the display of the projected screen when there is no signal input.Press1) as to select [BACK COLOR].Press2) qw to switch the item.The items will switch each time you press the button.f[BLUE] Displays the entire projection area in blue.[BLACK] Displays the entire projection area in black.[DEFAULT LOGO] Displays the Panasonic logo.[USER LOGO] Displays the image registered by the user.NoteTo create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.fIf you do not register the image of the [USER LOGO], the projected image will be displayed in black even if the [BACKfCOLOR] is set to [USER LOGO].[WIDE MODE]Using this function when displays the incorrect signals input.Press1) as to select [WIDE MODE].Press2) qw to switch the item.The items will switch each time you press the button.f[AUTO] Displays by judging the signal automatically. Set to this mode normally.[OFF] When input the 4:3 signal.[ON] When input the wide signals.[SXGA MODE]This function is used if the whole projected image is not displayed when SXGA signal is input. Set it to [SXGA] normally.Press1) as to select [SXGA MODE].Press2) qw to switch the item.ENGLISH - 63Chapter 4 Settings - [DISPLAY OPTION] menu
|
