118 S-ICX (International) issued October 2000 S-ICX-50-700Chapter 5. Key Telephone Features Section 700 - OperationHardware Requirements• N/AConsiderations• Calling parties without a display get a ring back tone, rather than the Absence Message.• If a message code number that has not been programmed is selected, Absence No.n, appears onthe display (n = message number).• Regardless of setting an Absence Message on a DDI/DL extension, DDI/DL calls are routedaccording to the trunk ringing setting.• An absence message may also be cancelled by dialling 7**. This cancels Do-Not-Disturb (DND)and Call Forwarding-All Calls as well.Account CodesDescriptionYou can assign account codes to clients to facilitate billing and to track call dates and times, numberscalled, and outside line numbers used. This information is printed for each account on the SystemMessage Detail Recording (SMDR) (Call Logging) record.In addition verified account codes may be used to change the TRS (Call Barring) level to allow callsto numbers otherwise restricted.Account codes may be either forced or unforced (voluntary) and either verified or unverified.This feature works with SMDR (Call Logging). During a phone call, a station user can silently enteran accounting or client billing code. The entered Code will display on the phone’s LCD as it’s dialled,so the user can tell it’s being registered. Then later, the Call Logging reports will show the Codedialled for each call, and even sort the report by these Codes.There are two different types of account codes: Non-Verified and Verified Account Codes. Prior toVersion 5.0, the maximum amount of account code numbers for both types could range from 1-10digits. Beginning with Version 5.0, a second mode has been added that allows the user to set themaximum amount of account code numbers from 1-4 digits. An account code error will occur whenmore than the maximum number of digits are entered.Non-Verified Account CodesNon-Verified Codes aren’t checked by the system for validity. Depending on the setting, the user canenter anything from 1-4 digits or 1-10 digits. Individual phones can be programmed to accept forcedAccount Codes (the user must enter a code for every call) or voluntary Account Codes (the user canenter a code, but doesn’t have to, for each call).Non-Verified Account Codes can be assigned to incoming and/or outgoing calls. For incoming calls,the user can enter the Code anytime during the call. For outgoing calls, the user either enters the Codebefore accessing an outside line (for forced Codes), or anytime during the call (for voluntary Codes).Verified Account CodesVerified Account Codes entered by phone users must match a code that has been preprogrammed intoan Account Code Table. Depending on the setting, the user can enter anything from 1-4 digits or 1-10digits. These codes can also be either forced or voluntary. You can program these codes with their own
