Section 700 - Operation Chapter 3. System FeaturesS-ICX-50-700 S-ICX (International) issued October 2000 69OperationTo set a Call Forward ID Code for Voice Mail:To clear the ID Code:Hardware Requirements• N/AConsiderations• N/ACLI/DDI Voice Mail ID CodeCLI/DDI calls may be sent directly to voice mail through the used of the DDI Voice Mail ID Code. Aprefix and suffix may be specified to be sent to the voice mail as well as a chosen number of DDIdigits.Either no digits (default), the last two digits of the DDI, the last three digits of the DDI or the entireDDI number may be sent.The prefix may be up to eight digits including 0-9, *, # and pause (REDIAL).The suffix may be up to eight digits including 0-9, *, # and pause (REDIAL).Hardware Requirements• N/AConsiderations• Each pause is a fixed 1 second delay.• If you do not assign a Voice Mail ID Code, the DDI digits will be sent to voice mail.Action Result1. Go offhook or press ON/OFF key.2. Dial the Call Forward ID Code (default = 715 [UK/HK or715# [Taiwan, Malaysia, Indonesia]).Enter V.M. ID displays3. Enter the ID code required by voice mail (see your voicemail manual). Usually this is the extension number.4. Press the HOLD key. Stored V.M. ID displays5. Go onhook or press ON/OFF key.Action Result1. Go offhook or press ON/OFF key.2. Dial the Call Forward ID Code (default = 715 [UK/HK or715# [Taiwan, Malaysia, Indonesia]).Enter V.M. ID displays3. Press the HOLD key. Cleared V.M. ID displays4. Go onhook or press ON/OFF key.
