Section 700 - Operation Chapter 3. System FeaturesDBS-2.3/9.2-700 DBS Manual - Revised April 2000 Page 3-74. Enter the Answer Signal Code (1 to 5 digits).5. Press the HOLD key.To view an answer signal code:1. Press the ON/OFF key.2. Press the CONF key.3. Dial “#94.”Considerations• The digits used for the answer signal code are determined by therequirements of the voice mail system.• If the called extension does not answer and is forwarded to voice mail, theDBS sends a call forward ID code back to the voice mail system.• During transmission of the answer signal code, other DTMF digits andfunctions from the DBS extension are ignored.Auto Day Mode(CPC-AII prior to 7.0 and CPC-B Version 4.0 to 6.11)DescriptionAuto Day Mode allows the DBS to go into day mode automatically.The DBS can also be programmed to go into night mode automatically (see“Night Service,” page 3-35).If only one of the auto modes is turned on, the NIGHT key is used to turn offthe auto mode. For instance, if night mode has been activated automatically,the attendant must press the NIGHT key to go into day mode.If only one of the auto modes is turned on, the NIGHT key can also be usedto go into an auto mode before the scheduled time.If both auto day and auto night modes are turned on, the attendant NIGHTkey cannot be used.
