Chapter 3. System Features Section 700 - OperationPage 3-8 DBS Manual - Revised April 2000 DBS-2.3/9.2-700Related Programming• FF1 (System): Automatic Day Mode Start Time• FF1 (System): Automatic Night Mode Start TimeConsiderations• If both auto modes are set, the starting times must differ by at least onehour.• When one auto mode is turned on, the mode cannot be reset by the NIGHTkey until 3 minutes after the auto mode is activated. (When both automodes are set, the NIGHT key cannot be used.)• If a NIGHT key is not assigned, the access code #52 can be used instead.Auto Day Mode(CPC-B Version 7.0 or higher and CPC-A II Version 7.0 and higher)DescriptionAuto Day Mode allows the DBS to go into day mode automatically.The DBS can also be programmed to go into night mode automatically (see“Night Service,” page 3-37).If only one of the auto modes is turned on, the DAY/NIGHT1/NIGHT2toggle key or the DAY, NIGHT1, or NIGHT2 is used to turn off the automode. For instance, if NIGHT1 mode has been activated automatically, theattendant must press the DAY/NIGHT1/NIGHT2 toggle key or the DAY keyto go into day mode. (Note: You must wait at least 3 minutes after theautomatic mode is activated before manually changing the mode. Otherwisethe system will immediately revert back to the automatic mode.)If only one of the auto modes is turned on, the DAY/NIGHT1/NIGHT2toggle key or the DAY, NIGHT1, or NIGHT2 key can also be used to go intoan auto mode before the scheduled time. If auto day and both auto nightmodes are turned on, the manual mode keys can be used.Related Programming• FF1 (System): Auto Day Mode Start Timer• FF1 (System): Auto Night1 Mode Start Timer
