EnglishVQT0K98154During recordingSymptom Cause and Correction ReferencepageRecording starts butstops immediately.Is disc scratched or does dirt or fingerprint adhere to it?Clean the disc. If there is still no improvement, replace the disc. 70If you turn this DVD Video Camera on for many hours in a hightemperature location, this DVD Video Camera may automaticallystop recording for the protection of the lens in the laser pickupassembly. In this case, follow the messages on the display of thiscamera. To start the recording again, turn thiscamera off and leave it for a while.Some vibrations are feltor slight sound is heardfrom mechanism.These vibrations or sound are caused by disc drive: This does notindicate a fault. LCD screen is hard tosee.Has brightness of LCD screen been adjusted?Stop recording and adjust the brightness. 86Is the DVD Video Camera being used outdoors?Use the viewfinder. When using LCD monitor, adjust its angle so thatLCD screen is not exposed to direct sunlight.35, 37Focus is not correct. Is it difficult to use auto focus with your subject?Focus manually. 63Does “MF” appear?The DVD Video Camera is set to manual focus. Focus the subjectmanually, or release manual focus.62Is the dioptre control correctly adjusted if you are using theviewfinder as a monitor?Adjust the dioptre control.35In cases other than the above, set the power switch to “OFF”, andthen set it to “ ”, “ ” or “ ” again. 48322