EnglishVQT0K9844Inserting and Removing DiscInserting Disc1 Press down the DISC EJECT button once andrelease it.A few moments after the ACCESS/PC indicatorblinks, the cover of disc insertion block will openslightly.2 Gently open the cover by hand until it stops.3 Insert the disc, in Round DVD Holder, into thedisc guide until it stops.Note that the recording/playback surface of discmust face the inside of DVD Video Camera. Theorientation for inserting the disc into the discguide is also predetermined: Load the disccorrectly, referring to the figure below.• The disc exposed portion must face in the same directionas the lens, as shown in figure.• The recording/playback side must face the inside (DVDVideo Camera).If the disc is not correctly inserted, the cover will notclose. Never try to forcibly close the cover: Thiscould cause damage. Reinsert the disc properly.4 Push the section marked “PUSH CLOSE” onthe cover of disc insertion block, to close thecover.5 Turn the DVD Video Camera on ( or ).When “DISC ACCESS” disappears, the DVDVideo Camera is ready for recording.●Identifying recording/playbacksides of disc:Single sided disc:The recording/playback side isopposite to the printed label.Double-sided disc:The recording/playback sideof “SIDE A” is opposite to the“SIDE A” marked side.The recording/playback sideof “SIDE B” is the “SIDE A”marked side.Disc coverDISC EJECTleverPUSH CLOSEportionDisc guideCorrectorientationIncorrect orientation“SIDE A” markThe opposite side isthe “SIDE A”recording/playbackside.212
