G.SHDSL Port Details window 121Models 2616RC, 3096RC & 3196RC Admin Reference Guide 9 • G.SHDSL (Model 3096RC)Figure 56. G.SHDSL port configuration section in Change mode• Change mode—You can view all the parameter values and modify the values for some of the parameters (seefigure 56). In Change mode, the T-DAC displays a Cancel button along with the Change Config button.Click Cancel to display the tables in display-only mode. In Change mode, clicking on the Change Configbutton refreshes the display. When you click the Change Config, the T-DAC retrieves parameter values cur-rently stored in DRAM and displays them on the page. Any configurable parameter values entered or selectedsince you last clicked (submit) will be overwritten with values retrieved from DRAM. When monitoring oper-ating status or statistics, or when defining new values for configurable parameters, use this button to updatethe display. You can watch any changes take place as they are reflected on the G.SHDSL port status display.Change Config buttonClick the Change Config button to display the port configuration tables in change mode. In change mode,clicking on the Change Config button refreshes the display. When you click the Change Config, the T-DACretrieves parameter values currently stored in DRAM and displays them on the page. Any configurable param-eter values entered or selected since you last clicked (submit) will be overwritten with values retrieved fromDRAM. When monitoring operating status or statistics, or when defining new values for configurable parame-ters, use this button to update the display. You can watch any changes take place as they are reflected on theG.SHDSL port status display.Cancel buttonThe Cancel button only appears when the G.SHDSL Port Details page is displayed in change mode. Inchange mode, the T-DAC displays the Cancel button next to the Change Config button, above the Port Con-figuration tables. To return to display-only mode, click the Cancel button. When you click the Cancel button,the T-DAC will re-display the Port Configuration tables in display-only mode.CO Configuration tableThe CO Configuration table (see figure 55 on page 120) shows the following parameters:• Line Provision Rate (gshDSLLineProbeRate)—Display-only. Indicates the recommended line rate calcu-lated by the T-DAC’s Line Probe (an on-board line rate provisioning tool). For more information about theLine Probe, see the section entitled “G.SHDSL Line Provision page”
