PPP-IPCP Chassis Management Channel 165Models 2616RC, 3096RC & 3196RC Admin Reference Guide 11 • In-band managementAfter the channel is UP, the In-Band Mgmt web page should appear similar to figure 96.Figure 96. Defined In-Band Management ChannelsThe definitions of various columns are similar to the T1/E1 management channel described previously. ForChassis Management Channels, only PPP is used. Frame Relay is not needed.The Interface Type is H.110 TX /H.110 RX.The statistics of the in-band management link are accessible via two paths. The first path is to click on thehyperlink in the Status column. For the second, click on the hyperlink in the Interface Type, then click on thehyperlink in the Statistics column.Example 2: Bridged PPP (BCP) Chassis Management ChannelThis example is to make a bridged-PPP chassis management channel between two Patton T-DACs. The chan-nel will be:Figure 97 shows how to configure the Model 2616RC for establishing a chassis management channel over themidplane bus to the 3096RC in the same chassis.Figure 97. Define an H.110 Management Channel1. The management channel will appear in the table as shown in figure 98. Notice that the Status is DOWNsince the other end of the PPP link has not been created. We need to change the Protocol Type from IPCPto BCP.Model 2616RC to Model 3096RCName: to3096RC Name: to2616RCBCP BCPIP Address: +10.10.1.2/32 IP Address: 10.10.1.3/322616RC 3096RCTx: H.110 Port 1:1 --------> Rx: H.110 Port 1:1Rx: H.110 Port 2:1 <-------- Tx: H.110 Port 2:1Check Default Gateway box.
