RIP Version 2 (Configuration) window 238Models 2616RC, 3096RC & 3196RC Admin Reference Guide 15 • RIP Version 2Bad Packets (rip2IfStatRcvBadPackets)The number of RIP response packets received by the RIP process which were subsequently discarded for anyreason (e.g. a version 0 packet, or an unknown command type).Bad Routes (rip2IfStatRcvBadRoutes)The number of routes, in valid RIP packets, which were ignored for any reason (e.g. unknown address family,or invalid metric).Sent Updates (rip2IfStatSentUpdates)The number of triggered RIP updates actually sent on this interface. This explicitly does NOT include fullupdates sent containing new information.Status (rip2IfStatStatus)Displays whether the RIP status for the Subnet IP Address is valid or invalid. One of the following values willbe displayed:• valid(1)—Data may be routed on this interface.• invalid(2)—Effectively deletes this interface.RIP Version 2 (Configuration) windowThe RIP Version 2 (Configuration) window (see figure 129) displays the configurable parameters for the singleRIP routing domain defined by the IP Address displayed at the top of the table. You can use the RIP Version 2Configuration window to view and modify the parameters for the routing domain. The configurable parame-ters are Domain, Authentication Type, Authentication Key, Send, Receive, Metric, and Status.Do the following to display the RIP Version 2 Configuration -window:1. On the RIP Version 2 main window, in the RIP Configuration table, under the Address column, identifythe RIP address you wish to view.2. Click the Address link.Figure 129. RIP Version 2 (Configuration) windowThe following sections describe the configurable parameters displayed on the RIP Version 2Configuration window.
