iDSL Port Configuration window 136Models 2616RC, 3096RC & 3196RC Admin Reference Guide 10 • iDSL (Model 3196RC)Figure 69. Color-coded port status exampleColor-coded port status indicatorsThe iDSL Port Status table displays colored rows (see figure 69) to indicate port status for each port. Thecolor-coded indications are described below:• Green—The port is currently in dataMode(1) state. An iDSL link is established with the remote CPE. Thelink is ready and able to transfer data.• Blue—The port is operating in one of the following test modes:- localLoop(1)- remSerLoop(2)- lineLoop(3)• Yellow—The port is currently in initializing(1) state and the link establishment timer has not expired• Orange—The port was in initializing(1) state and could not establish the iDSL link, therefore it moves tolineDown(7) state.• Red—The port is currently in hardware failure state (see section “Current State (idslCurrentState)” onpage 135)Desired State (idslDesireState)Configurable. Indicates the T-DAC operator’s current intentions for the port.• Deactivated(0)—Default value. The T-DAC operator intends the port for future use. Use this value whenthe port is not currently connected to a remote CPE modem.• Activated(1)—The T-DAC operator intends the port to be connected to a remote CPE modem for currentactive use• Reset(2)—The T-DAC operator intends to reset the iDSL port.Test Mode (idslTMSelection)Configurable when the value of port State is one of the following:• initializing(1)• datamode(6)
