2–Driver Installation and ConfigurationVMware Driver Installation and Configuration18 BK3254601-00 C2. Install the driver VIB using the following esxcli commands:a. To make a temporary directory, issue the following commands:mkdir /installcd /installb. Issue the following command:esxcli software vib install -v /install/Verifying the Version of the Installed DriverTo verify the installed package in the system, issue the following command:esxcli software vib list | grep qla2xxxThe driver version is embedded in the VIB version.For example, the output looks like the following:# esxcli software vib list | grep qla2xxxscsi-qla2xxx 911.k1.1-16vmw.500.0.0.406165 VMwareVMwareCertified 2011-09-21Installing QConvergeConsole VMware vCenter Server Plug-inTo use QConvergeConsole VMware vCenter Server Plug-in, install the followingsoftware in this order:1. QConvergeConsole VMware vCenter Server Plug-in on the vCenterServer2. QLogic Adapter CIM Provider on the ESXi serverThe following sections explain how to install and uninstall the required software: “Installation Package Contents” on page 19 “Installing QConvergeConsole VMware vCenter Server Plug-in” on page 19 “Plug-in Unregistration from a Manual Install” on page 25 “Uninstalling the QConvergeConsole VMware vCenter Server Plug-in” onpage 26 “Installing the QLogic Adapter CIM Provider” on page 26 “Uninstalling the QLogic Adapter CIM Provider” on page 29For information on installing the Plug-in, refer to “Installing QConvergeConsoleVMware vCenter Server Plug-in” on page 19.
