3–Fibre Channel ConfigurationConfiguring the UEFI Driver56 BK3254601-00 CConfiguring OoOFR with Noninteractive QConvergeConsoleCLITo enable OoOFR in the noninteractive mode of QConvergeConsole CLI, issueone of the following commands:# qaucli -n instance>| wwpn> EnableReceiveOutOfOrderFrame 1# qaucli -n instance>| wwpn> EO 1Where:To disable OoOFR in the noninteractive mode of QConvergeConsole CLI, issueone of the following commands:# qaucli -n instance>| wwpn> EnableReceiveOutOfOrderFrame 0# qaucli -n instance>| wwpn> EO 0Configuring the UEFI DriverThis section provides information on configuring the unified extensible firmwareinterface (UEFI) driver contained in the multiboot image. UEFI 2.x systems use ahuman interface infrastructure (HII) to configure motherboard devices and plug-inadapters. QLogic Fibre Channel Adapters use an HII to configure adapterparameters and boot-from-SAN settings.To configure the UEFI driver for Dell:1. During system boot, press the key corresponding to your platform.2. On the Dell System Setup window, select Device Settings, and then pressthe ENTER key.hba instance = Adapter number (use the -g command to find)hba wwpn = Worldwide port name of the adapter
