Q150T Sample Preparation System10473 - Issue 5 14 Q150T - Instruction Manual2.3.2 Electrical Connections1. Connect the instrument to a suitable earthed single-phase ac supply using thesupplied cable. The lead should be fitted with the appropriate plug for yourcountry. Ensure the plug is firmly located.WARNING – EARTH CONNECTIONThis Equipment must be Earthed and fitted with the correct lead for thecountry of operation. This Equipment is normally supplied from 3 pinsupply including Earth.For fuse information, refer to Table 32.2. Connect the rotary pump power lead to the Pump Output connector on the rearpanel (see Figure 2-3). If the rotary pump has its own switch, ensure that this isset to the ‘On’ position.WARNING – PUMP OUTPUTCheck that the Power Output is suitable for the rotary pump. The PumpOutput is intended for connection to the pump supply only and providesthe electrical supply voltage at a maximum of 4 Amps.PIN UK AND EUROPE U.S.A. AND CANADAPin 1 ( Live or Hot) Brown BlackPin 2 ( Earth ) Green / Yellow GreenPin 3 ( Neutral) Blue WhiteFigure 2-3. Power outlet lead wiring2.3.3 Aux Network ConnectionTo link the Q150T to your network, use a standard CAT5/5e cable with RJ45 networkconnectors to connect the AUX Network port directly to your computer’s network port or anetwork hub/switch.Pin 3NeutralPin 1LivePin2Earth
