RADWIN 2000 Considerations Appendix HWinLink™ 1000 User Manual Release 1.9 H-5Figure H-5: Radio Frame PatternFive RFP types (A to E) are available. The RFP is selected depending on thetype of the radio products, services and channel bandwidth used by thecomplete system.Select the RFP that gives you the Best Fit for the system services and selectthe Channel Bandwidth accordingly.The table below describes the efficiency of the WinLink™ 1000 air interfaceaccording to the RFP type, radio products mix, services and channel band-width. The table may be viewed in the RADWIN Manager and in the LinkBudget Calculator and varies according to the product used.RADWIN 2000 ConsiderationsRADWIN 2000 radios use a Radio Frame Pattern of 1250 millisecondsregardless of HSS. Hence the RADWIN 2000 performance, as calculatedwith the Link Budget Calculator, does not “care” if the radios operate in HSSmode or not.WinLink™ 1000 ConsiderationsWhen WinLink™ 1000 radios are collocated with RADWIN 2000 radios usingHSS, all radios must use a Radio Frame Pattern (RFP) of 1250 milliseconds.Note• RFP type E should be used if and only if RADWIN 2000 links are partof the HSS installation.• The RFP must be the same for each link within the collocated system.Table H-2: Radio Frame Pattern Table - ExampleRadio Product Mix RFPChannel Bandwidth20 MHz 10 MHz (WinLink™ 1000 only) 5 MHz (WinLink™ 1000 only)TDM Ethernet TDM Ethernet TDM EthernetWinLink™ 1000 onlyA Best Best Fit Fit -- --B -- -- Best Fit Best FitC -- -- -- Best -- FitD -- -- -- -- -- BestWith RADWIN 2000 E Fit Fit Fit Fit -- --
