Installation Chapter 5WinLink™ 1000 User Manual Release 1.9 5-153. You may make any further changes to the Service Configurationor the Jitter buffer. When you are satisfied, click the Evaluate.The optimum transmission rate for the selected services is evaluated.Following a short delay for processing, Back and Next areenabled.4. Click Next to continue.Step 6, TDM Clock ConfigurationThe following dialog is displayed:Figure 5-18: TDM Parameters Configuration (1)¾To configure TDM clock parameters:1. For any individual port, click it. For the same parameters for allports, click the Select All tag.2. Click Configure. The following drop down list is displayed:NoteThe transmission rates used by WinLink™ 1000 are shown in Table 5-4above.Note• Select Maximum will select the maximum number of services thatcan be carried by the air interface• Select All unconditionally selects all of the services
