Chapter 5: Virtual Media97Connecting to Virtual MediaLocal DrivesThis option mounts an entire drive, which means the entire disk drive ismounted virtually onto the target server. Use this option for hard drivesand external drives only. It does not include network drives, CD-ROM, orDVD-ROM drives. This is the only option for which Read/Write isavailable.Note: KVM target servers running certain versions of the Windowsoperating system may not accept new mass storage connections after anNTFS-formatted partition (for example, the local C drive) has beenredirected to them.If this occurs, close the Remote Console and reconnect beforeredirecting another virtual media device. If other users are connected tothe same target server, they must also close their connections to thetarget server.Note: In the KX II 2.3.0 and above, when you mount an external drivesuch as a floppy drive, the LED light on the drive will remain on becausethe device is checking the drive every 500 milliseconds to verify the driveis still mounted.Note: In the Dominion KX II 2.1.0 and above, when you mount anexternal drive, such as a floppy drive, the LED light on the drive willremain on because the device is checking the drive every 500milliseconds to verify the drive is still mounted.To access a drive on the client computer:1. From the Virtual KVM Client, choose Virtual Media > Connect Drive.The Map Virtual Media Drive dialog appears.2. Choose the drive from the Local Drive drop-down list.
