232In This ChapterOverview ................................................................................................232Accessing the KX II Using CLI ..............................................................233SSH Connection to the KX II .................................................................233Logging In ..............................................................................................234Navigation of the CLI .............................................................................235Initial Configuration Using CLI ...............................................................237CLI Prompts ...........................................................................................238CLI Commands ......................................................................................238Administering the KX II Console Server Configuration Commands ......239Configuring Network ..............................................................................240OverviewThe Command Line Interface(CLI) can be used to configure the KX IInetwork interface and perform diagnostic functions provided you havethe appropriate permissions to do so.The following figures describe an overview of the CLI commands. SeeCLI Commands (on page 238) for a list of all the commands, whichinclude definitions and links to the sections in this chapter that giveexamples of these commands.The following common commands can be used from all levels of the CLIto the preceding figure: top, history, log off, quit, show, and help.Note: Both IPv4 and IPv6 addresses are supported.Chapter 12 Command Line Interface (CLI)
