100 ST7001+ Autopilot Control Unit - Owner’s Handbook7 Adjusting Autopilot SettingsLatitudeThe ST7001+ only displays this screen if you have set AutoAdapt tonth or Sth. Use the -1,+1, -10 and +10 keys to set the value to yourboat’s current latitude, to the nearest degree.Note: If valid latitude data is available via SeaTalk or NMEA, theST7001+ will use this data instead of the calibration value.Magnetic variationThis is the degree of magnetic variation. This screen also appears inUser Calibration – see page 90 for full details.Autopilot resetNote: Not available on Type 100/300 autopilot systems.WARNING:Do NOT use this feature unless advised to do so by a Raymarinedealer. If you complete a reset you will lose ALL autopilotcalibration settings. You will then need to repeat the autopilotcommissioning process.Selecting an autopilot reset will reset all of the autopilot calibrationvalues in the course computer:• all of the settings in User Calibration, Seatrial Calibration andDealer Calibration will return to the factory default values• the settings in Display Calibration will not change, as these arestored in each individual control headTo reset the autopilot:1. Select the Autopilot reset (RESET) screen in Dealer Calibration.2. Press the +1 key.3. The screen will then show an ARE YOU SURE message:• press the +1 key again to select ‘YES’ and reset the autopilot• alternatively, press the disp key to cancel4. You will then see the CAL LOCK screen:• press standby for 2 seconds to save the new default settings,then turn the course computer power off and back onScreen text RangeLATITUDE 0° to 80° in 1° steps
