Copying_ 51. Press (Copy) on the control panel.2. Place originals, face up, in the document feeder. Or you can use thescanner glass with a single original document face down and closed thescanner lid.3. Press Menu on the control panel.4. Press the up/down arrow to highlight Copy Feature and press OK.5. Press the up/down arrow to highlight WaterMark and press OK.6. Press the up/down arrow until the binding Message option you want ishighlighted and OK.7. Press the up/down arrow until the binding Pages option you want ishighlighted and OK.8. Press Stop/Clear to return to ready mode.9. Press Start to begin copying.Copying both sides of the originalsYou can set the machine to print copies on both sides of paper.The Duplex options may vary between document feeder or scannerglass.1. Press (Copy) on the control panel.2. Place originals, face up, in the document feeder. Or you can use thescanner glass with a single original document face down and closed thescanner lid.3. Press Duplex on the control panel.4. Press the up/down arrow until the binding option you want is highlighted.•Off: Prints in normal mode.•1->2Side Short: Prints pages to be read by flipping like a note pad.253•1->2Side Long: Prints pages to be read like a book.•2->1Side: Scans both sides of the originals and prints each of one on aseparate sheet.•2->2Side: Scans both sides of the original and prints on both sides ofthe paper. This function produces exactly the same print out from theoriginals.•2->1Side ROT2: Scans both sides of the original and prints each oneon a separate sheet, but the information on the back side of theprintout is rotated 180°.5. Press OK to save your selection.6. Start copying a document.Setting copy timeoutYou can set the time the machine waits before it restores the default controlpanel settings, if you press Start button prior to the control panel restoringto default, the previous job will be reprinted.1. Press Menu on the control panel.2. Press the up/down arrow to highlight System Setup and press OK.3. Press the up/down arrow to highlight Machine Setup and press OK.4. Press the up/down arrow to highlight Timeout and press OK.5. Press the up/down arrow until the time setting you want is highlighted.Selecting Off means that the machine does not restore the defaultsettings until you press Start to begin copying, or Stop/Clear to cancel.6. Press OK to save the selection.7. Press Stop/Clear to return to ready mode.
