Samsung OfficeServ 7400 Technical Manual

Also see for OfficeServ 7400: System administration guide User guide User instructions General description General description

Contents

OfficeServ 7400 PROGRAMMINGTECHNICAL MANUAL PART 2 JUNE 2006MMC: 315 CUSTOMER SET RELOCATIONDESCRIPTION:Customer Set Relocation allows System Administration level or Technician levelaccess to relocate or exchange similar stations in the OfficeServ 500 without wiringchanges (see Allow Table bellow). This program is a one for one exchange with likestations. All individual station assignments such as trunk ring, station group, stationCOS, station speed dial, button appearances, etc. will follow the Customer SetRelocation program. iDCS 18 button keysets and iDCS 28 button keysets can beexchanged. Add On Modules and 64 button modules can also be exchanged. Ifincompatible set types are selected the system will provide an ERROR: NO MATCHmessage. If AOM or 64 button module units are to be exchanged the Masterassignment must be removed prior to using Customer Set relocation. If the AOM or64 button module Master station is not removed the error code ERROR: NOTALONE will appear on the LCD display. A station must be in the idle state (on hook)to perform Customer Set Relocation. If a wired location has a station port connectedbut no telephone instrument the Customer Set Relocation program will allow setrelocation as long as the station types are similar.iDCS 18 button and iDCS 28 button key assignments should be taken inconsideration when relocating these types of sets due to the button configurationsof the instruments. If a 18 button set and a 28 button set are exchanged using theCustomer Set Relocation program the first 18 buttons on the 24 button set will havethe button programming of the 18 button set. In other words, when exchanging 18and 28 button set only the first 18 buttons will swapped.NOTE: Customer access to this feature is default OFF in MMC 802.